GIS Visualization Lab

Access

Students, please Register for access to the GIS Visualization Lab.
After registration access to the lab (your card will be activated to open the door) and an account in the GVL Scheduler below will be granted.
GIS workstations can be reserved in the GVL Scheduler
and used from 7am - 10pm M-F.
Processing new users will be done in batches at the start of the week.  

Make a Staff Consultation Appointment.
Consult for help, advice, and assistance with
3D printing, Laser Cutting, Plotting, Model Making (Physicall and Virtual), General Orientations and more.

The GVL Scheduler offline due to security issues. 

GIS Visualization Lab POLICIES

• Access to the GIS Visualization Lab (GVL) is for authorized users only (those who have DocuSigned the general-wiaver.pdf and whose id card can open the door), unless arrangements have been made with the Lab Manager or Student Worker. Authorized users may use and reserve the GIS workstations in the lab unattended. Other resources are available through appointment with the GVL manager or Student Worker.

• The Laser Cutters must always be watched while cutting, no exceptions. Failure to do this may result in a loss of GVL access as it is a fire hazard. If, due to negligence and misuse of lab equipment, repairs are required, users will be liable to pay for such repairs and must be re-trained.

• A list of approved materials for the laser cutter is listed below. Any material not listed must be reviewed for safety and approved by the Lab Manager or Student Worker.

  • • Mat Board (Museum Board) - max thickness 0.125"

    • Paper - recommended 80 lb. and above

    • Cardboard - max thickness 0.375" (Common c-Flute 0.125" and E-flute .0625" recommended)

    • Chipboard - max thickness 0.0525″

    • Bass, Poplar, Balsa Wood - max thickness 0.25”

    • Plywood - max thickness 0.25”

    • Acrylic - max thickness 0.5”

• 3D Printing [FDM]: File review and supervision with a Staff Consultation appointment is required for the first 3D print job in the lab and until unsupervised 3D printing is approved by Staff. Filament not approved by Staff cannot be used.

• The design and construction of weapons of ANY kind is prohibited and requires notification to UCSD Police Department.

• UCSD is a state-funded facility, and as such may not sponsor “for profit” functions in the GVL. Users are not allowed to use the GVL for building things to be used as fundraisers or to directly sell to others. The GVL supports users who are using the Lab as part of instructional or research activities.

• Before using a machine, receive instruction on proper use. Do not use any machine that you are unfamiliar with...ask for help.

• Report any damaged machines, or safety concerns immediately.

• There is no space for storage - what you bring in you must take out.

• All users are expected to clean up after themselves by recycling or appropriately disposing materials before leaving the GVL.

• Sharp objects must be properly disposed.

• There is no eating in the lab. You are only permitted to bring drinks in closed containers.

• Alcohol, drugs, and all controlled substances are always prohibited in the Lab and users deemed to be "under the influence" or fatigued are not allowed to enter the GVL or use any of the equipment. GVL staff have the obligation to require users showing signs of weariness or an inability to follow safety or use instructions to leave the facility until a later time.